- Should drywall joints be tight?
- What is an acceptable gap in drywall?
- Is it better to hang drywall vertical or horizontal?
- How big of a gap can you fill with drywall mud?
- Can you use 1/2 inch drywall ceiling?
- How far apart should the screws be when hanging drywall?
- Does drywall have to end on stud?
- How big of a hole can you fill with drywall mud?
- Should there be a gap between drywall and floor?
- Why do you hang drywall from the top down?
Should drywall joints be tight?
Drywall Joints Are Too Tight Not only that, but you have to allow for expansion and contraction of the underlying framing members.
Natural seasonal expansion of the wood framing can crack drywall joints that are too tight..
What is an acceptable gap in drywall?
How big a gap is acceptable? Between panels, 1/4 inch is fine. Taping compound and tape will cover it with little difficulty. Putting on a coat of compound before setting the tape will fill the gap. If you are using mesh self adhesive tape, forcing a bit of compound through the tape into the gap couldn’t hurt.
Is it better to hang drywall vertical or horizontal?
On commercial jobs, fire codes often require seams to fall on the entire length of the framing, so the drywall must be hung vertically. However, on residential jobs, the drywall on the walls is typically hung horizontally. For walls nine feet high or shorter, hanging the drywall horizontally has a number of benefits.
How big of a gap can you fill with drywall mud?
You can usually fill gaps less than 1/2 inch wide with joint compound while you are taping, but joint compound cracks when used to fill wider gaps. The solution is to fill the gaps with patching compound or, if they are especially wide, with strips of drywall.
Can you use 1/2 inch drywall ceiling?
SHEETROCK UltraLight Panels are ideal for use on ceilings with up to 24-inch on-center framing and water-based texture, presenting potential cost-savings when used as a replacement for 5/8-inch type X board used on ceilings or 1/2-inch interior ceiling board. …
How far apart should the screws be when hanging drywall?
Start screwing the drywall to the wall studs (Image 4), sinking each screw below the surface of the drywall, spacing the screws 12 to 16 inches apart.
Does drywall have to end on stud?
4 Answers. But two is a must. Your drywall should end on stud or be butted up in the center with another piece of drywall. Either cut your drywall or add more studs.
How big of a hole can you fill with drywall mud?
Use spackle to repair holes less than 4 inches (10 cm) in diameter. Spackle can be used to repair holes up to the size of your hand. You will have to use a support like mesh or wire to repair holes larger than 4 inches (10 cm) in diameter.
Should there be a gap between drywall and floor?
Always leave a 1/2-inch gap at the floor. This allows for floor and wall expansion without cracking the drywall.
Why do you hang drywall from the top down?
When hanging drywall, always hang the ceiling first. This is the hardest drywall to hang, so get a partner and go slow. Large cracks due to misaligned sheets are hard to repair because the extra mud required to fill them will constantly fall out and drop to the floor (or worse, down the back of your neck!).